CFS - Coating & Finishing Services
Coating & Finishing Home Page
Coating & Finishing Services
CFS Brochure PDF Download
Contact Coating & Finishing services
Coating & Finishing Profile


The Old Brickworks,
Harborough Road
Pitsford, Northampton. NN6 9AA

Tel: 01604 881140
Fax: 01604 881141
Email: click here to launch










  Coating & Finishing Profile

Coating & Finishing ProfileBecause the products which we see have so many varied demands placed on them, we give your products individual attention when considering how best to protect them within their performance environment. Your product may not be subjected to environmental corrosion, but it may have to perform within set flame retardancy limits. Each performance demands and each environmental feature will alter the final coating and finishing specification and each demand and feature must be met if performance is to meet expectation.

Paint specification is undertaken to BS4800 and RAL standards liaising with architects, structural engineers and consultants.

  The paint shop uses a wide range of application equipment from gravity fed spray guns to pressure pots and airless & air assisted units. All painting areas are fully heated to facilitate the simultaneous painting of different colours where necessary.

Powder coating is, in most cases a viable commercial alternative to conventional industrial wet painting. A hard, high gloss finish and depending upon the resin type used, corrosion resistant. Both excellent coverage and good opacity are produced with a standard powder. Another advantage to powder coating is that a more uniform higher film build can be obtained in one single application than can be achieved with liquid paint. Powders are normally supplied by the box, ready for immediate use, thus eliminating mixing ratio errors.